![]() ![]() Clear cookies of medium clicking on that Lock icon in the address bar. Type Bypass Paywalls Clean and tap Create collection. Users would have to subscribe and/or purchase the media to view the post. Just wondering if there's any free databases similar to kemono. Never hammer cable connections onto battery posts, as this can damage the battery posts and cover. Replace cables, ensuring positive cable is first followed by the negative. Place and tighten the hold downs securely so that the battery cannot move in the tray.Īpply a thin coating of high temperature grease to the posts and cable connections. Place the new battery in the tray, ensuring it sits level and that terminal posts are positioned same as the battery. If terminal clamps or cables are badly corroded, they should be replaced. Terminals should be cleaned and brushed.Ĭable and starter motor connections should be checked and tightened if necessary. If necessary, scrub the area with a water and baking soda mix and rinse with water.Ĭorroded steel parts should be dried and painted with acid proof paint. Undo hold down clamp and remove the battery from the vehicle.Ĭheck battery height to ensure there is sufficient bonnet clearance. This precaution is necessary to avoid damage to wiring and the battery by accidentally grounding tools. Note the location of positive terminal and mark polarity on positive cable. The drive cycle is usually defined in your vehicle manual. If you need to reset the battery management system (BMS), FOB or Idle Stop Start (ISS) system in the case of the warning below, the drivability of the vehicle will be restored after completing at least one drive cycle. ![]() A battery backup can be used to retain memory by plugging a power source into the cigarette lighter socket, OBD (On Board Diagnostic) plug or using jumper leads on the positive terminal lead and earthed to the vehicle body. In vehicles that have a computerised electrical system, disconnecting the battery may erase memory from the engine control module (ECM), transmission control module (TCM), clock, radio, security codes and navigation systems. Remove the keys from the ignition and if the vehicle has a Frequency Operated Button (FOB) with keyless entry, the FOB should be kept at least 2 metres clear of the vehicle. ![]() Before attempting to disconnect and reconnecting the battery from the vehicle, ensure all electrical equipment is turned off including the ignition system, air-conditioning, lights and radio. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |